Passer au contenu
Video Library

Installing a T-Type In-Pipe Cable on a Tiny-House Water Line

Video by GoTinyBeFree · 8:03Open original on YouTube ↗
What to take from this video

The key planning step is matching the cable and entry fitting to the full pipe route—not just the length of exposed pipe you can see.

The project: exposed supply pipes beneath a tiny house

Hans from GoTinyBeFree shows the water supply beneath his raised tiny house. The exposed pipe has frozen in previous winters, and he describes an earlier external heat-tape setup that stopped working. His project uses a 6 ft T-Type in-pipe heating cable and a replacement section of 3/4 in PEX.

The video follows the pipe work and reconnection. It is an installation walkthrough filmed before winter, rather than a season-long test of freeze protection.

What the installation actually shows

Hans introduces the T-entry fitting, compression seal and factory-finished cable before working on the supply line. He explains that the seal can be repositioned to change the length inserted into the pipe. This is an adjustment at the seal; it is not permission to cut the heating cable.

Later in the video, he replaces part of the PEX run, installs the T-fitting, feeds in the cable and reconnects the water supply. The close-ups help show how the cable enters the line and how the fitting sits beneath the house.

What to check before copying this layout

Check the internal passage through every fitting, valve and bend. A nominal pipe size alone does not establish that the cable will pass through the complete route. Do not push or pull the cable through a restriction.

Protect the rest of the water system too. An in-pipe cable does not automatically protect nearby valves, exposed connections or other pipe sections that it does not reach. Follow the product instructions for insulation and for any heating section left outside the pipe.

YeloDeer installation notes

Disconnect electrical power and isolate and release water pressure before opening or adjusting the assembly. Complete the water-pressure and leak checks before restoring electrical power. Never shorten, splice or modify the factory-finished cable.

Self-regulating cable adjusts its heat output as temperature changes; it does not switch itself off. Use a compatible controller if automatic temperature-based on/off operation is needed, and follow the instructions for both products.

Questions about this video

Can I cut the cable to fit a shorter pipe?

No. This video shows adjustment by moving the seal, not by cutting the cable. Follow the model-specific instructions for any heating section remaining outside the pipe.

Does this show the system working through a full winter?

No. It shows the installation and water reconnection. It does not establish performance for every winter condition or pipe layout.

About this video

GoTinyBeFree states that YeloDeer supplied the cable and a small payment for this video.